Sheme of Boards

Sandworm 3D printer - Scheme of Boards:

Signpost:

• Main

• Scheme of Boards

• Drive Mount

• XY Axis

• Z Axis

• Chassis Top

• Chassis Middle

• Chassis Bottom

• Electronics

• Extruder

• Filament and Spool

• Levelup Addons

• PrusaSlicer

• Tools

• Bill of materials (BOM)

• Gallery
  

Tools that will be needed:
- Circular saw - longitudinal sections (for plexiglass: saw blade with 48-50 tooths)
- Jig Saw - Carving the inner corners 
- Angle grinder - with multi material disc (for wood, plastic and nails)
- Cordless drill
- Step drill 5-32mm, 6mm drill and 4mm drill
- Paint color, brush, foam roller and sandpaper...

Board thickness:
Plywood thickness: 6mm
Plexiglass thickness: 5mm

Processing Plywood Boards After Cutting and Drilling:

• Paint the boards before mounting, applying three coats

• After the first coat, lightly sand the surface using 240-400 grit sandpaper

Note: It is not necessary to use the exact tools mentioned. (For example, instead of a jigsaw, you can use an angle grinder with a multi-cut disc for wood, plastic, and nails). However, the boards must be cut with a maximum deviation of ±1mm—the more precise, the better.

Note for Plexiglass boards:
For boards, cheaper Acrylic plexiglass can be used (instead of Polycarbonate), with the default heating setting using the print bed, the chamber will not reach temperatures higher than 50 °C (PTC chamber heater is limited by macros up to 60 °C). The stated temperature resistance of acrylic plexiglass is 60 °C with load, 80 °C without load.

File Formats:

• The board cutting schemes are available in PDF and STL file formats under the download files tab.
  
  

Additional 3D printed accessories in this Section:
This section also contains files for 3D printing that mount to the Door Plywood Board:
Door Handle and PSU Fan Grill. These files are stored in a separate download folder: 3D models for Door Plywood Board.

• ⚠ Insert four M3 heat-set nuts into the PSU_fan_grill model.

Roadmap:
Drive Mount →  Chassis Bottom →  Chassis Top →  Chassis Middle →  XY Axis →  Z Axis →  Electronics →  Extruder →  Filament and Spool  →  Levelup Addons  →  PrusaSlicer →  GitHub

For to return to the main page: Sandworm 3D printer - Main page