Satsana 4010 fan gasket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gasket to seal off gap between 4010 fan and satsana fan duct.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Noticed a gap between the outlet of the 4010 fan and the inlet to the Satsana fan duct. Not sure if this was specific to the version of Satsana I was using but I've seen it mentioned elsewhere as well so I doubt that's the case. I wasn't sure if the gap was really affecting the strength of the airflow much if at all. Editing the fan duct itself would've also worked but I figured it would be a more universal and easier fix if I simply made a gasket instead, since I had also made other changes to the duct for my hotend set up in particular that wouldn't work for everyone. I printed mine in black TPU and it seems to fit just right, so perhaps it might also work in rigid materials although I didn't test that. If you want a tighter fit maybe scale it up in the Z axis by about 2-5% (only for flexibles).
I installed mine with the protrusion going into the inlet of the fan duct. I did not try installing it with the protrusion going into the fan outlet, but I don't think it will be any different how you choose to install it.
Print with flange on the bed. No supports required.