Quad Ultimate Nozzle Wiper for Prusa XL
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
4 times the silicone tube nozzle clean
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 499
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Following the inspiration of CrashKG's Nozzle Wiper for Prusa XL remix, I wanted to see if I could make a quad version in the same footprint of my Double Ultimate Nozzle Wiper for Prusa XL. That way it would be compatible with my individual XL Debris Bucket - Low Profile for Ultimate Nozzle Wiper for Prusa XL Extended Length or XL Debris Bucket - Low Profile for Ultimate Nozzle Wiper for Prusa XL Full Length.
I made cut outs in the base to allow the most clearance for the screws yet retain the support for the silicone tubes.
Screw installation was a tight fit but it is doable. When installing the M4 button head screws, screw it in at an angle. Then straighten it out once it is in. Once the screws are in place, insert the silicone tubes on holder. Now you are ready to add them to the Prusa XL.
I purchased 7mm OD 3mm ID silicone tubing and used Schweinert.com's Cutter for ultimate Nozzle Wiper to cut the tubing down to size. (2) M4 T-Nuts and (2) M4x8mm button head screws per nozzle wiper.