Technical improvements for V3.0 - DIY RC DumpTruck
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Various improvements for easier printing, stronger parts, 8xAAA battery pack.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 171
- Wydruki
- 0
- Wyświetlenia
- 1002
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
25-dumpbed - cabin cover - This is the cut piece from the dump bed. Glue it to themain part with superglue
5mm_LED_Mount - Instead of buying led mounts, you can print this part. You need to use also 16-hood-8.2mm light
13-front-wheel-support-wider - Provides cable refief. Use together with 10-steering-linkage-wider
11-front-wheel-n20-motor-mount with stoppers centered - Adds a lot of support and strength of the front wheels + cable relief
electronics cover - use to cover the electronics if using an 8xAAA battery pack
24-dumpbed-pushrod better fit stronger - better fit and easier to print, stronger
25-dumpbed - main - main part of bumpbed. uses much less or no support
26-dumpbed-pivot no screw but filament pivot - use filament rivets instead of screws
18-grille - simplified grill
5-rear-tire - easy to print, no support required