1 / 7
Yoga Slim 7 (Gen 8) - front rubber feet — zdjęcie 1
1 / 7

Yoga Slim 7 (Gen 8) - front rubber feet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Front rubber feet for Lenovo Yoga Slim 7 (Gen 8).

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
73
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

One of the rubber feet of my Lenovo Yoga Slim 7 (Gen 8) fell off and got lost, so I modeled this replacement in Fusion360, transferring the measurements from the remaining one. It was really annoying to use the laptop like this, since I felt I was bending it when resting my palms over it. 

It is NOT needed to print using TPU, if you don't have TPU, and don't want to spend money on a new TPU reel: PLA works just fine. 

My recommendation: Do not use superglue, first print in different sizes in a range of 99% of the size to 103% of the original size (it is so little material that I do not consider it waste). Then try the best fit, and use only a very small, a tiny piece of strong double sided tape. Even better, just barely scratch some of the glue on the tape and use it to hold the new 3d printed foot in place. Now my laptop feels even again, as new :).

Tagi