1 / 7
Spacer for converting 6 D-cell Maglite to 5 18650s — zdjęcie 1
1 / 7

Spacer for converting 6 D-cell Maglite to 5 18650s

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

MAKE SURE YOUR LIGHT BULB CAN HANDLE THE VOLTAGE. GOING FROM 9volts TO 24VOLTS

Ocena
0 / 5
Polubienia
4
Pobrania
20
Wydruki
0
Wyświetlenia
193
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution

Here are all the parts I used to convert this flashlight to lithium, and from Halogen to LED.

  1. Print the above spacer.
  2. Print 5 of these 18650 to Dcell form factor adaptors by isquared:  https://www.printables.com/model/759117-battery-adaptor-18650-to-d-cell
  3. Get an LED bulb that can take at least 21 volts.  Here is the one I got from Amazon:  https://www.amazon.ca/dp/B07YBS4X67?ref=ppx_yo2ovbought_dt_b_fed_asin_title (eecoo 2 Pack Flashlight LED Bulbs, 5W 6-24V P13.5S LED Flashlight Bulb, Led Conversion Kit for Torch Tooling Lantern Work Light Bulbs Replacement)
  4. You will need some extra hardware as can be seen in the pictures, to conduct power through the spacer.  This can be done many ways, so I just used some nuts and bolts I had available).  I used Bolt: 49x6.20mm , nut: whatever fit, washer 27mm outer with 8mm hole.

Freecad file attached because open source is awesome!

Side note, I realized during the conversion that the LED takes 6-24 volts, therefore if given the chance it will deplete the five 18650s in series to a point where they may not be rechargeable.  Thus I strongly recommend keeping an eye on voltage every few hours, or implementing a circuit within the spacer to disconnect or flash the light upon low voltage.  If you create a solution before me, please post it and let me know!

Tagi