Foot for Kids Ikea Mammut plastic chair
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for dome shaped chair bottom.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 618
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
These indoor/outdoor table and chair sets (from Ikea I think - Mammut?) often lose a foot because they fall out and get lost.
It's an odd shape with the flat spot having to be at the correct angle. I prefer to fill the volume with infill, rather than just making a shell, to help spread the load from the flat part to the rim and outer diameter of the leg.
Print this, in the colour that's closest to your chair colour and snap it in. I used PLA which was easily strong enough for smaller kids. Print with the large flat side on the build plate and use supports for the rim that runs around the bottom edge. I used 4 walls but 3 should be OK too. I used 30% infill.
Print one or two extra for when the next ones gets lost.
Use large layer lines (0.24mm or 0.28mm) and increase width to 0.5mm or 0.6mm. No-one will ever see the layer lines for this part under the chair leg.