10-24 Nut cropped to fit 1/8 inch slots
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
10-24 nut short enough to fit 1/8 inch slots. I was printing parts with 10-24 nut slots that were too narrow otherwise.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 96
- Wydruki
- 1
- Wyświetlenia
- 229
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
I liked SmilingImpact's 10-24 bolt and nut design but needed a nut short enough to fit 1/8 inch (roughly 3.5mm) nut slots. This nut remix is made to be 3mm tall so it fits easily into slotted parts.
From testing, 0.1mm layer height is ideal. You can get by with 0.25mm but the imprecise threads may make tightening difficult.
Overtightening may cause the threads to strip or the nut to snap, depending on plastic used. Suggest light-duty use only.
No supports required.
Use 100% infil.