Streamlight Wedge Picatinny Mount

This model is designed to allow the Streamlight wedge, my edc flashlight, to easily be attached to a standard Picatinny rail. I have tested the piece out a bit and found that the light is securely held in the mount and the only way I could get it to start to slide out was by essentially dropping the whole assembly on its end. Even swinging it around over my head the light didn't budge.
The part was designed to accept charging port covers in place as mine has, but I would verify the fit before printing just in case. My cover is 13mm at it's widest point and the gap along the side and end was designed 14mm wide.
I am also including a short video about attaching it to the rail as it takes a little bit of force as it doesn't have a traditional clamp mount as to keep the design simple and not require any additional hardware. I even tried to make a version without supports and the tab on the other side, but it was too difficult to get the clip on without fear of breaking the print, so some supports are necessary.

Print with the rail locking lug at the top to minimize the amount of supports necessary.

My Settings:
Printer- Ender 3 V3 SE
Slicer- Cura
Resolution- 0.2
Walls- 0.8 thick, 2 line count.
Infill 10% Zigzag
Filament- PLA (I used Anycubic, a cheap amazon find)
Generate supports- Yes (tree) 
Adhesion- Brim