Magnetic clip for hydration backpacks or hippacks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A magnetic clip for easily securing the hose tip from your hydrationpack to your back- or hip pack straps
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 157
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed a stronger magnetic clip for my ‘Evoc Hip Pack Pro 3’ hydration hip pack and while I was designing this, I decided to make it a clip on baseplate. Now I can easily add one to any packpack strap with a width of 24mm. It slides onto any backpack or hippack strap and stays nicely secured, even if the strap is wider than 24mm it will stay secure, because of added ridges on the inside of the base clip.
The hose clip opening holds a 9mm Evoc or Decathlon hose tightly, a 8.5mm Camelbak hose will hold well too.
Two 15mm x 3mm Neodymium magnets will be needed to glue 1 in the base clip and 1 in the hose clip. Using superglue/cyanoacrylate glue works great for this. Just make sure everything is degreased and cleaned properly before glueing!
Print the base upright at 0.2mm layerheight, with the tapered part on the plate, this way you don't need supports. This printing orientation also gives a lot of strength and won't easily break.
The clip is made in two parts to prevent the need of supports and also giving added strength to the clip securing the hose, because of the print orientation. Add a drop of superglue/cyanoacrylate on either part and fit them together.
Preferred material: PETG
Print settings: 0.2mm layer height, 6 walls, 5 top and bottom layers
Needed hardware: 2x Neodymium magnets 15mm x 3mm