Hakko Smoke Absorber Shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A shroud to add some ducting to the Hakko Smoke Absorber, when used in the face-down mode.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 148
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a shroud for the Hakko Smoke Absorber when used in the face-down position.
Problem: I found that in the face-down orientation and with an Amscope microscope stand, it couldn't get close enough to capture the solder smoke most of the time. I'd usually need to cup my hand to guide the smoke in, and even then, this wouldn't work all the time.
It's meant to be taped down to back with a little bit of thin, double-sided tape.
Unfortunately, this requires a little super-glue to put it together, as it was much easier just splitting this into multiple parts than trying to find a thin, easy-to-print option that didn't require more material in supports than the model itself.