Monitor Mount Generator Parametric OpenScad
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Many monitor have a click-on attach which is mainly based on tabs. This model allow to define your own.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 25
- Wydruki
- 1
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Many monitors have a click-on attachment, which is mainly based on tabs. This model allows you to define your own.
The provided STL is for the DELL U2412 Mb.
Even though it should ideally support the monitor without screws, I decided to add the option to use them. I personally used screws with my monitor.
Apart from the 100x100 holes (VESA standard) used to attach the support to the monitor, I also added holes for a 75x75 VESA mount.
In both cases, you can decide if you want to create the screw head chamber, the type of head, and where (inside or outside).
The model supports three screw heads: flare, nut, and cylinder.
I used the VESA 75 holes to attach the monitor to a multiboard by using the Heat Set Insert - Push-Fit. Another option is using a French cleat mount like the one I made https://www.printables.com/model/997159-french-cleat-generator-parametric-openscad .
In any case, you can decide the distance of the holes if you have a different distance for your mount.
The SCAD file also allows you to create small pieces to test the holes for your screws.
I used PETG with the standard 15% infill. PLA (especially PLA+) should be fine as well.
Any suggestions are more than welcome.