Anycubic M7/M3 Series Resin Pump Cap Seal
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple TPU gasket for the resin pump cap that comes with some Anycubic printers
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 115
- Wydruki
- 0
- Wyświetlenia
- 644
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Some Anycubic resin bottles can be a little off and the pump cap was not designed to tolerate much deviation from the intended bottle neck profile.
This seal sits around the internals of Anycubic's resin pump cap to insure the critical air seal still happens even when your cap sits slanted on the bottle. The specific version I have tested is the one that comes with the M7 Pro, but should also work for the version that came with the M3 printers.
I found that using Polymaker PolyFlex TPU95 works very well even with printing on the textured build plate.