Frame Motor for Kossel / Deltaprinter 20x20

This is sort of a remix from the Kossel "frame_motor_2020sw".
Which means i created the thing completely new in fusion360.

I could not found the source because there are so many of these parts on thingiverse.

Changes i made:

• changed the distance for the motor, to ad a vibration damper which i found here
  https://de.aliexpress.com/item/Hot-sale-5-pcs-lot-Nema-17-stepper-motor-Vibration-Damper-shock-absorber-for-42-step/32764435765.html
• made the cutout for t-nuts bigger
• made holes through the whole part for tighten the screws for the motor
• made a small cutout on the underside for cables (endstops)
• smaller radius next to the screws, which holds the motor for adding washers

• just 3 instead of 4 from this long sections parallel to the extrusion
  Version 1: Tested. A little bit hard to insert the extrusion, and not to much space for cables on the underside.

  Version 2: Tested. Bigger cutout on the underside (radius 5mm instead of 2.5mm), smaller radius in the corners, where the extrusion goes through (0.5mm instead of 1mm)

  Version 3: Tested. Small update. Rounded the corner/area where the cable bends from the underside to the extrusion. Had some troubles to move the cable, when the extrusion was in place. And changed the logo slightly :-)

  Any feedback is welcome

Print instructions

Category: 3D Printer Parts Print Settings

Printer Brand: Prusa

Printer: Prusa Mk2

Rafts: No

Supports: Doesn't Matter

Resolution: 0.25

Infill: 20%