Marvel Villainous Insert w/ Expansions (Sleeved)

This insert should fit almost 100% of the Marvel Villainous content listed on Boardgamegeek.com (as of 09/06/2024) into the original box with sleeved cards and only about 4mm of box lift. It likely will not fit the Power and Strength tokens from all expansions. The base plus expansion tokens are probably even more than are needed. 

The card boxes will fit sleeved decks with Sleeve Kings 60 micron sleeves. They are designed to fit snugly so cards do not just fall out but are easy to insert and remove. If you use thinner sleeves they will be loose, if you use premium 100 micron sleeves I doubt they will fit. Skip to the end for link to CAD files if you need premium sleeves.

While this is inspired by other designs, it is a ground up redesign. My design shaves off roughly 140 grams of material from the sleeveless design and prints in less than half the time (6h13m/360g vs 15h30m/500g). It will also prevent your tokens from going everywhere if the box is shaken or tilted. The token holders are also quicker to refill during cleanup.

Most of the parts will print double walled in vase mode. Try printing one deck box first, it should only take 10-15 minutes. If it has a gap in the wall that is not connected then you are under-extruding (or have the ultimate dimensionaly accurate FDM printer). All the deck boxes will have a gnarly seam on one corner, but they are sturdy and print very fast. 

If you have a large format printer you can print up to 4 of the deck boxes on one build plate if you have your extruder clearance configured properly and you enable the “by object" print sequence. Smaller printers can likely fit 2 or 3 at at a time. 

Parts List:

Print in vase mode:

Doctor Octopus.stl
Hela.stl
Infinite Power Fates.stl
Kang.stl
Killmonger.stl
Loki.stl
M.O.D.O.K..stl
Madame Masque.stl
Mischief & Malice Fates.stl
Taskmaster.stl
Thanos.stl
Titania.stl
Twisted Ambitions Fates.stl
Ultron.stl
Venom.stl
Villain Movers - Large Bed.stl (print the 2 part version if it doesn't fit)
Villain Movers - Part 1.stl
Villain Movers - Part 2.stl

Print in standard mode:

Token Tray - Character.stl
Token Tray - Power & Strength.stl

Optional vase mode:

Token Tray - Spacer.stl

Print this if you only have the base and one of the larger expansions. This keeps the token tray flush to the lid. Print it in vase mode and flip it upside down on the bottom under the player boards. It's not needed if you're only missing We are Venom. 

Disclaimer and CAD link: 

If you want to modify my design for premium sleeves it is available here https://cad.onshape.com/documents/850c1b07feb187f93c69349b/w/1bcd67ff638675c7ad6015b5/e/e1cc6bd66957591f4d96b686?renderMode=0&uiState=66db5b470e1714795c1b7b2f. You can either make your own copy in OnShape or export the pieces to files that will work with your preferred cad program. 

EDIT: I now own all the expansions and it has been fully tested. No modifications were needed.