Plastic wrap holder for kenwood chef
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
a ring that holds the plastic wrap firmly sealed against the bowl of a kenwood chef stand mixer
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 329
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
a typical plastic wrap roll is around 30 cm wide, and the Kenwood stand mixer bowl is only 23.5 cm in diameter..a match made in heaven! Or so l thought...
every time I tried to put plastic wrap on my bowl so that my dough can proof in there without needing to use another container, I had much more trouble than I needed to in order to keep it in place! I got as far as having a dedicated rubber band, which however was just a little too small and made things even more annoying :D
hence, I designed this super simple and print friendly disk, and every problem was solved! The film stays in place very easily, and firmly.
For printing, no special care or supports are needed, just make sure that
- you have the right bowl. I'm guessing they might change from one model to another. Just measure that the external diameter is 235 mm
- as stated in #1, the disk has a diameter of 235mm, which means you will not be able to print it in a typical prusa printer. In this case, I suggest you print in quarters. Then you can joint it all together, or just leave it in quarters - this would also save you some drawer space :)
- is “level the bed” outdated??
- the disk will not come in contact with food if used correctly, but if you want to be safe, use food safe filament
enjoy!