Liczymy pasujące modele…
Heavy duty desktop clamp vise with interchangeable grips. The vise can rotate for more convenience. The larger parts can all be printed at 0.2 just fine. The rest I highly recommend printing at a lower layer height especially the 2 bolts…
Toothpick dispenser similar to what you'd find at a restaurant at the front desk. The dispenser roller is omnidirectional (rotate backwards and forwards) to dispense a toothpick. I've only tested this with Diamond round toothpicks (6.5mm…
Dual PS5 controller holder. Requires 9 supports. Feet are optional but need to be made of TPU (2 of each will be needed). Inserting the supports will require some force. Dimensions are 6.87" x 8.66" x 7.79" (174.5 x 220 x 198).
An alternate solution to the "joystick hanger" type PS5 controller under table holder.
Vertical stand for Trigkey/ Beelink mini PCs. The PC slides in from the front. Feet are optional and should be made from TPU.
Simple dagger design with decorative pommel inserts. Center support should be printed in PETG. Blade length: 9.64" (245mm) Handle Length: 4.66" (118.5mm) Guard Length: 6.1" (155mm) Total Length: 16.42" (417.3mm)
Vent gauge pod for Audi A4 / S4 (B8 / B8.5) for 52mm gauges. Install location is the left center vent.
This is a modification of my original Logitech MX Ergo Mid Body Stand 45° with the difference being an additional 20° tilt. It uses the original metal base and is held on with up to 6 10x2mm magnets (you only really need 3) and it's…
This is an all in one solution for your Logitech MX Ergo. The mouse sits at 45°. It uses the original metal base and is held on with up to 6 10x2mm magnets (you only really need 3) and it's recessed so there's no risk of the base sliding…
Kitchen sink strainer with 132 holes (~4mm x 4mm). Iron all top surfaces for longevity.
Simple under table remote holder for the LG Magic Remote that comes with LG OLED TVs.
Simple cable combs that holds them at a 90° angle. The key clips in to prevent the cables from pulling out and to keep them pushed in all the way. I recommend using a softer filament like Polymaker PolyTerra for the added flex so it's…
The original casing for the Anker 555 HDMI hub is fine but it gets quite warm. This case should help keep temps down. I used some 1.75mm clear PETG filament in the power LED hole on the top.
I wasn't happy with how restrictive the stock top cover was so I created this. Cover is friction fit so don't be concerned if both don't just fall right in. Put the ends in first then push the centers in. SIDE NOTE (The USB-C is missing…
To wszystkie aktualnie dostępne wyniki.
