Liczymy pasujące modele…
Made this simple riser block for the top lid on my X-max3. Didn't want to take the lid of when printing PLA so this was a simply fix for that. It has two small taps that slots into the holes in the frame. It fits both in the front and in…
I'm in the process of modifying an printer where i want to use a Voron dragon burner tool head. I had to make some modifications so i needed a 3D model of the hotend for my Xmax3 so i drew it up in Inventor so i could make an assembly.…
Here is a bracket i designed for converting my CR10 Max to linear rails on the Y axis. No modification to the bed is needed! The bracket uses alignment tabs on the six big holes on the bed (three on each side) You will need to source six…
Upgraded to an linear rail on my CR10-Max. Designed a new cover with deeper countersunk holes so the original bolts could be used again. The x axis limit switch sits a little further in and the cover is longer so it clears the linear…
Sonic pad holder for a CR10-Max Uses the front two M3 holes that holds the bottom plate. You will need to source two M3x12 bolts, the original bolts aren't long enough Prints fine with no support. You might have to remove a small string…
Being stuck at 1300/1500 acceleration with the original dual shaft stepper sucked! So i took some inspiration from the CR10-S5 which used a similar setup with one stepper. This helped a lot and i'm now running 3500 acceleration with 450…
I needed a light above the build plate on my CR10-Max printer. So i found a LED lamp from V-TAC model number VT-035 and designed a new holder for it so it could be mounted to the 20x20 aluminium extrusion profile. You will need to print a…
The original Qidi inductive probe failed on my printer and i had a Super pinda laying around from another project. Dimensions have been taken from the original Qidi mount, so no need to edit the printer.cfg as the X/Y offset is the same.…
I somehow misplaced the headtube cable guide that was on my Trek Rail ebike. So i took the guide of my Fuel Ex and designed a new one that's very similar to the old one. Trek's part number is: W5257896 I've added multiply models depending…
I needed a nozzle holder for the oddball M6x0.75 nozzles that my CR10 max uses, so i designed this little holder/plate. I've modelled the threads and made them slightly over sized so that it should be possible to screw the nozzles in by…
Can't be printed! You have to make them on a lathe or CNC mill. Beefier redesign of the 18mm long M10x1 bolt that's used on full suspension Trek mountain bikes. Trek part number: W509392 i made them in Stainless steel AISI 316L.
I wanted to mount a Nevermore V6 in my Xmax3. So i designed this blanking plate that does double duties. Both blanking off the exhaust fan hole and has mounts for this Nevermore V6 holder.…
Designed this to make the part cooling fan wiring a bit easier. BOM: 3x2 LDO JST XH splitter 2x M3x5x4 heat inserts (from voron BOM) 2x M3x10 BHSC screws 2x M3x8 BHSC screws Print it in ABS/ASA with voron print settings
To wszystkie aktualnie dostępne wyniki.
