Liczymy pasujące modele…
This reel holder is designed to easily swap out reels of surface mount parts. It's designed to sit on the floor below your part feeders. It's a low cost design which uses two 0.5" PVC pipes and no fasteners. Everything just presses on and…
I designed these PCB Holders and Feeder Strips to clip to the edge of the build plate on the Lumen PNP using 0.75" binder clips. This design allows for both the feeder and the PCB to be mounted anywhere on the build plate. It is only…
This feeder is designed to be set up as an Auto Feeder in OpenPNP. I designed it to mount to a Lumen PNP. It uses an Arduino Mega which listens to GCODE sent over a USB serial connection in Open PNP. The Max Feeder Shield can control up…
This model allows you to make your own Grove connector using 2mm header and your 3D printer. Here is a link to where you can buy some 2mm header: https://www.amazon.com/Uxcell-a15062900ux0315-Single-Straight-Connector/dp/B012TBLZTC/…
The Volcano hotend lowers the nozzle closer to the print bed. This BLTouch mount moves the BLTouch 7.5mm closer to the print bed to account for the longer Volcano hotend. You're probably fine printing in PLA, but I'd still print in…
This allows you to use a 550mm linear rail which is easier to source than the stock 525mm rail.
This vacuum pump mount allows you to replace the rubber bands holding the vacuum pumps without removing the mounts from the staging plate. This model has modeled in supports that can be easily cut or snapped off after printing.
To wszystkie aktualnie dostępne wyniki.
