Liczymy pasujące modele…
The Solder Scroll makes soldering more ergonomic by allowing you to just scroll on the pen shaped tool to add solder. By rotating the knob, the tool can be adjusted to accomodate different diameters of soldering wire (0.3 - 1.5mm). A…
Wydruk około 1,48 €–1,80 € nettoWstępna wycena jednego wariantu
Keep your photos organized and protected. Has 5 separate compartments so the photos will stay upright. Will fit 5 x 17 photos. Print with flat sides on the print bed. Printed at 0.2mm layer height.
Inspired by DFV Tech's design. Was not fully satisfied with the strength of the locking clip as it could easily release on the front. This design goes around the hook which prevents this. Quick print done with PLA at 0.2mm layer height.…
Prints without any support in a short time. Printed with 0.2mm layer height. Prints best with the long side on the print bed.
The Blade Station is an add-on for your workbench to quickly change the blade of your jigsaw. It allows you to install the blade without getting your fingers near the sharp teeth. There's space for your 3 most used blades (of 100mm total…
This design can be adjusted to your needs (or to the things you already have) by changing the parameters in fusion 360. Don't make too big adjustments at a time as that may sometimes result in some weirdness with the model. The size of…
Dry a lot of desiccant (or just a bit) with this stackable basket system. Requires a Polydryer drybox and the Polydryer itself. All parts can be easily snapped together. Make sure the "i" of the tab is oriented towards the inside of the…
This phone tray allows you to easily align your phone with the IKEA Livboj wireless charger. It solves the issue with aliging your phone correctly. A couple of times I woke up with a phone that did not charge and decided to do something…
This shelf support is designed for shelves that are at least 25cm deep. The end connection part has to be printed two times. Holes for screws to attach the support to the wall and the shelf are incuded. The connecting parts are designed…
I created this photo frame to display my Instax square photos. Easy to swap out photos. Assembly: Place the photo in the front frame. Slide in the back piece from the bottom until it clicks into place. Place it into the stand. Notes: To…
To wszystkie aktualnie dostępne wyniki.
