Liczymy pasujące modele…
I recently moved into a house wich has less storage room in the kitchen. For instance to store the lids for pots and pans. This simple model I whiped up can be used to easily store these on the inside of a kitchen cupboard door. Print 1…
All 26 letter keychains. Can be printed in single color, and in multiple colors using pauses on certain layer steps. Printed in PLA, but can be done in other materials. When printed at 100%, the keychains are approximately 3.5 cm high.
Show off your plants using this pot/planter. It prints fine in vase mode, i got the best result using a .4mm nozzle and setting the wall size to .8mm in printing vase mode. Test your own printer/slicer settings, it might be different for…
Print tested in PLA on various scaling sizes. I used a Brim when scaling down smaller. Should print fine without though. Nothing noteworthy in terms of settings, should print ok on any printer/slicer combo. Hope someone likes it.
I needed a hook to hang up a clothing such as abathrobe, and this simple print works just fine. It fits the IKEA Brimnes door perfectly. I printed mine in Polymaker PETG, 0.2mm layer height, using a 0.4mm nozzle. PLA also works, but this…
A simple print used to store away stuff on the wall. Can be used to store a drying rack (like I did) or scaled up and used to store extention cords or hoses. I printed in PETG and used 0.2mm layer height and a 0.4mm nozzle.
Start your plants on the windowsill using this 6 box seed starter tray. Printed and tried out in both PLA and PETG, and it holds up well in the sunlight.
I was toying around with the idea of a planter in multiple colors, and parts that you could interchange. The result is this simple, yet i think lovely result. You could print all parts in the same colour, or change it up. My version the…
A simple yet clean solution to store the multiple attachments you can use with a Dyson vacuum. Works for the small attachments up to the large mopping ones. Attaches to the wall with 2 screws. This mount allows you to snap in the…
I needed a solution to hold my filament on the inside of an IKEA bror storage solution so I created this simple model. You can mount it using the screw/nuts that come with the IKEA system. Print it in PLA/PETG using sufficient walls and…
A simple clamping mount/hook to store a broom or mop hanging from a door. Can be printed without supports in PLA or PETG. My version is printed using 0.2 layer height and 0.4mm nozzle
To wszystkie aktualnie dostępne wyniki.
