Liczymy pasujące modele…
I replaced the HSW anchors with those provided by the super robust hooks I linked to in the remix section. Version 2 of this file has a slant/slope so that the tool can't slide out over time.
Print with supports standing up. Should only require a few supports and prints relatively quick considering it holds a huge battery. I printed with 15% infill and it holds up fine.
------------ Printing Instructions ------------- Filament: PETG (NO PLA! The HSW anchors I chose will snap like yo momma's back!) Infill: 60% Fill Pattern: Gyroid Wall Count: 5 ------------ Remix Notice ------------- This is a remix.…
Ziptie box that can be mounted on the HSW (honeycomb storage wall). Yes, it does need supports. I wouldn't use PLA for this because it's too brittle for this type of mount. Nuff said.
The M3 nuts have to be placed inside the slot where they will attack to the hard drive cage with the pointy side of the nut pointing up, not the flat top pointing up. You just take a hammer or something heavy and gently hit it until it…
Remix, this is the description from the original -- Reuse old pegboard dual/fork attachments in the Honeycomb Storage Wall. Both two and four H4 Inserts Supported (M3 probably fine). Printed in PLA but PETG fine. 0.6mm nozzle, 0.3mm layer…
This is a spray can holder for the HSW (Honeycomb Storage Wall) that takes up very little filament and supports a lot of weight. If you plan to add a lot of spray cans make sure you print at a higher infill. So far, I have printed at 95%…
I downloaded the stand but found out that it didn't fit the old AMS. Here is the part that will make it fit the old AMS.
This device enables mounting toilet safety rails directly on the wall. Some fancy toilets or bidets remove the ability to mount a toilet rail on a toilet. This is a workaround provided the toilet is not too far from a wall. Printing…
Here is a modular flush fit set of containers for the HSW. I have a bunch of different sizes but I included the blender file so you can modify at-will. I use it for nailgun nails. Use PETG because of the type of HSW anchor being used. The…
To wszystkie aktualnie dostępne wyniki.
