Liczymy pasujące modele…
This is a basic spacer for the Raspberry Pi Pico. I'm using it by gluing the spacer to another part, which leaves the Pico still easy to remove. It is meant to be used on the top face of the Pico, and it's the same thickness as the Micro…
This is a wire comb I made for straightening out Cat6A cable before crimping. You put this on your index finger and then pull the wire between your thumb and the comb, along the grooves. It makes straightening out the wires way easier,…
My desk was running out of space, so I designed this print to mount volcas in a rack. It takes up 3U. Print two of the models, face down. These are joined in the back with some M5 heatset inserts and a piece of MDF I had laying around.…
I wanted a few faders on a small controller, but the available options on the market were way too expensive. So I designed my own. Full build instructions and firmware here: https://github.com/JennToo/MidiSliders
BOM Atomic Pi ($60 USD) Meanwell RS-25-5 power supply ($13 USD) StarTech ST4202USB hub ($19 USD) M3 heat-set inserts (Voron spec ones, can't remember the exact size) Mains inlet (can't remember where this came from) Small 5V fan Overall,…
Some simple legs to prop the SQ-64 up at a nicer viewing/working angle. It re-uses the M3 screws on the back of the unit. Just take those out, guide them through the leg, and screw it back in. I used 3 legs total, but 2 would probably be…
This is for holding dilators upright after use, to avoid making a mess with the dilators falling over. It is designed for the 4 standard-size Soul Source dilators. If you don't know what dilators are, this print isn't for you! If you look…
I queued up a print at about seven or eight And I yelled to the ABS yo, holmes smell you later Looked at my enclosure, I was finally there To sit on my throne with the Fresh Prints of Bel Air Print Settings Filament: Prusament (pink) and…
To wszystkie aktualnie dostępne wyniki.
