Liczymy pasujące modele…
NOTES: I printed at 150mm/s so my tolerances are probably not the best… but I noticed the third largest Allan key slot is a bit tight (but still fits) and the smallest Allan key slot is definitely too tight to put it in all the way. At…
This is a replacement pin for the window slider kit for my Danby AC unit (DPA110CB5BP). Might fit others. Picture shows the prints before I re-centered the interior hole (as it was printing 2 lines on one side and one line on the other…
A simple weatherhead / service head sized for a press fit on a 34mm / 1.33" OD tube. I printed in PETG for outdoor use.
Two versions of my conduit box for storing the extra cabling for my Reolink cameras. Option3 has thicker walls and has a smaller box volume (3" wide x 4" long x ~1.375" tall with 0.25" thick walls), however I felt stuffing the cables so…
A track for Ethernet cable to run in that should clip under hardiplank siding. Will print soon. Edit: Tried printing the original version and the slight overhang of the ‘tab’ parts caused issues… and it was a bit skinny which made it hard…
Scaled up 15% and added a small cutout so that it clips in place on my round bars. Bars are ~5/32" diameter.
To wszystkie aktualnie dostępne wyniki.
