Liczymy pasujące modele…
Remix of JesusFreak vented riser. Split into parts to allow printing in different colors. The vents (blue) slide in the bottom and then the hole is plugged with the plug (red) by gluing the tabs at each end. The handle/toggle is designed…
24/08 V5 added. All now printed and fitting 26/08 V6 Rear added width guides. 26/08 Added Shelf Support. 2 M4x4x6 heated insert. 2 supports needed each side and something to bridge between to make a shelf.
iPhone 14 Pro lens protector for TPU
TC-TS 2025 table saw track. Modified from original to make a mitre slide: -Extended to 299.6mm -Added option of 4 x 4mm knurled nut heat insert -Insert holes are separated by 80mm each for easier measuring. Print as is with supports.…
Lenovo Tiny M720q IOCrest 2.5g plate
SV06 Plus Frame brace, attaches over the top of the original Z top bracket which i think is more accurate.
Blanking plate to fit mini rack.
I brought a 25ft pressure washer pole to do the gutters. Before i preshure washered though and got covered i wanted to use a scoop with a ACME thread. Not wanting to buy another pole with this thread i remixed and added to join a M22…
Remix for mounting in a corner
This is a modified base from the original by Eiral https://www.thingiverse.com/thing:4212064 -Bottom bump removed so it sits flat on the bed -Top overhangs modified so alot less support is needed Updated 20/04: Added modified arm. -Allow…
Remix of original with minimal support. Also fixed the inside as the original wasnt flat at the bottom Lid v2 is a more snug fit. Added massage gun bracker. Need a M6 x 40 bolt and a few self tappers. Drill a 6mm hole in the side of the…
Made this so i can cut a plastic spool, move filament from a cardboard spool by sliding accross and then rejoining. Recommend not cutting the plastic spool straight and doing it at a angle/messy to act as a key when putting the spool back…
The bearings at the rear of the Twotrees TS2 are only friction fitted. Over time they work their way out causing the bar to move around. Spacers designed to butt up against the inner bearing ring and the red belt guide. I printed 9 at the…
Needed a battery box for 3 Yuasa NP7-12 for a Eaton UPS expansion but couldnt find anything. 2 of these fit perfictly inside a "The Range" 10 litre container. Print Settings Printer: Artillery Sidewinder X1 Rafts: No **Supports:** No…
To wszystkie aktualnie dostępne wyniki.
