Liczymy pasujące modele…
I made this exhaust pipe plug to use when I wash my motorcycle. It will fit exhaust tips from 12mm to 38mm inner diameter. It's modeled to print without supports or brims on its side. The small flat section it sits on does not affect its…
Aftermarket tailgate handles for this Tundra are very weak and the whole mechanism has to be bought to get a replacement handle. After going through 2 of them I modeled this replacement and beefed up the areas where it sees the most…
I designed this chain guide insert to fit with the stock YZ 125 chain guide aluminum shell. It is almost identical to the stock rubber insert. I can confirm it fits into a 2005 and 2006 stock chain guide. It's designed to be printed as 2…
I designed this to replace the stock lower chain roller on my 2005 YZ 125. Printed 100% infill in TPU. Just insert your 608 bearings and you're good to go.
I designed this replacement petcock gasket for my YZ 125 gas tank. Printed 100% infill out of TPU. It's slightly thicker than the stock one and seals nicely.
To wszystkie aktualnie dostępne wyniki.
