Liczymy pasujące modele…
This is a very simple two-piece pan/tilt gimbal for a Caddx Nebula Nano (the standard camera shipped with most Vista kits) or any other 14mm wide camera, a standard-sized 9g pan servo (ideally one with 180° of rotation or more), and a…
Compatible with the Tesla Model 3 (pre-Highland, 2021-2023) or Model Y center console. Print in PETG, ABS or other heat- and strain-resistant materials. PLA will soften in the hot cabin in the summer, not recommended. Print flat on the…
I designed these mounts to attach outriggers to the wings of my Mini Talon VTOL build. The mounts connect the pre-existing twin carbon fibre tube spars inside the Mini Talon wing to 14mm strong longitudinal outriggers hanging underneath…
Build a simple filament holder rack between two walls - inside a cabinet, shelf, wherever. Materials required: 2x 15mm pipe / tube (aluminum works well) or round wood profile 2x these supports between 4-10 self-tapping screws some piece…
A rear motor mount for a tricopter. Concept based on the RCExplorer tricopter motor mount using Hobbyking steerable landing gear mounts, but with better attachment and motor mount options. Can be bolted onto 10mm or 15mm wide booms…
Three-piece stand that angles your Eureka Mignon coffee grinder 15° forward. Print in any material, PLA may deform with time but has held up for years for me in this application. Use four M3 screws and nuts to attach the feet to the base.…
This is a simple two-part motor mount, designed to fit a standard brushless motor with a 16mm/19mm M3 screw pattern to a 14mm carbon fiber tube. It is primarily intended for use on multirotor frames. Print using ABS or PETG at high infill…
Allows to mount a SPC+ Micro Stem Mount on the handlebar stem of a Koga F3 bicycle, while being flush to the curved surface. Print in TPU for ideal weather sealing. PETG or PLA also works fine.
Holder for two large(-ish) wrenches in a Gridfinity drawer. Fits a 22/24mm wrench that's just under 25cm long. No magnet or screw holes in the base. Let me know if you need a model with them, I can make a variant.
This is an Aero Pod for the CP215KOA frame. I designed and test-printed it for use on my unibody CP215, but it should also fit the version with separate arms. The pod is designed to fit the following hardware: HS1177 FPV camera with a…
To wszystkie aktualnie dostępne wyniki.
