Liczymy pasujące modele…
I needed a book riser for my kallax which was not as tall. So I shortened it to about 9 cm. During that process I removed the grid and replaced it with crossing structural beams. Recommended print settings: .28mm layers and 10% infill
A I4 Channel based on the Underware project by Hand on Katie . Perfect to route in cables from the side when the multiword ist not mounted via screws but mounted with VHB tape.
Improved Roller for the Drybox with a curved slope on the ends to prevent the spool from slipping
Mount to use the Dragonfly BMS on Ender 5 S1 with Linear Rails suited for the Linear Rails Upgrade from Pugwash . For use with heated inserts. Recommend Print Settings .1 layer height 40% infill ABS or higher temperature resistant materials
This Model is only the bottom case. The top case can be found in the original model and requires no alterations. I reworked the original base to fit the waveshare PoE boat (tested with Rev3). Print Settings Same as the original (3 walls,…
A mount for the sonic pad on the top aluminium extrusion for Ender 5 and Ender 5 S1 with a raised mount for an 8mm wide led strip. The strip has a 30° angle Recommended print settings .2 layer height 15% infill any filament
This plate can be used to grow cuttings as hydroponics. Simply place them on a jar or something similar. That way the leafs don't touch the water and can't rot easily. The top has a conical shape so water is able to drain into the jar. It…
To wszystkie aktualnie dostępne wyniki.
