Liczymy pasujące modele…
Replacement blades for the Durafly Auto g2 V2. The blades are designed to be printed in 3 pieces with ColorFabb LW-pla (regular PLA may also work). Print vertically with no supports, no infill, using the supplied config file. I found that…
This mount only requires 1 screw in the ceiling and consists of multiple parts that can be printed flat to optimize layer orientation. I found other RC plane mounts lacking because either their hole spacing required mounting into drywall…
This model provides a cheap and universal means for reliably measuring the static thrust of your brushed or brushless motors. It is powered independently of the motor, allowing a wide variety of configurations to be tested. Build Video…
The golden age of river travel can be alive and well in your bathtub with this rubberband-powered paddle-steamer toy. Two paddle wheels and a smokestack give you all the power and stability you need to traverse the mighty Mississippi…
Print with organic supports and 15% infill
Always found it annoying that I had to lift the entire lid off of the filament dryer. So I decided to fix that and I created a simple hinge and handle to make filament changes so much easier. The hinge will work on either the front or the…
replacement ESC / receiver tray for hobbyzone aeroscout
FPV canopy for the Eclipson Cobra. The canopy 1 file was modified to have a nano FPV camera mount and wire pass-through port. The canopy 2 file was modified to have a 20x20 VTX mounting-point, an SMA mounting point, and wire pass-through…
Low wing can mount inverted while high-wing can mount rightside up. The rods are mounted at an approximately 15deg angle meaning the plane will be pressed against the surface as it is inserted, providing a secure hold with friction alone.…
To wszystkie aktualnie dostępne wyniki.
