Liczymy pasujące modele…
In order to cool my SB2040 canbus-board (with extruder-driver onboard) I used to have a 30mm fan cover sitting on my Clockwork2 extruder. Now switching to Galileo2, noone seems to have designed such cover, only for smaller 25mm fans…
Welcome to the 10inch project! In an effort to combine all my home devices for networking into a 10" rack, I designed several mounting brackets for my devices which are not tailored to any rack standard. All designs are driven by the…
My own version of a tube key to squeeze everything out of a tube, e.g. toothpaste tube. This design allows to slide the key towards the tube which prevents it from unwinding by itself! Category: Bathroom
Version 2 is available now! Outdoor Weather Station based on ESP32 and BME 280 Little outdoor weather station with ESP32 (NodeMCU and similars) box which can be mounted to a rail or similar (clamp diameter 22mm). It has an arm to hold the…
Remixed to fit slightly different layout. For glueing instead of screwing.
Box and lid for ESP32 modules (NodeMCU boards and similars). The BME280 version offers a mount point for the sensor below the main board. Also, the box then has vents. However, testing revealed that the board gets so warm that the sensor…
Outdoor weather station v2 with esp32 board and BME280 sensor Hi all, finally it's time to release v2 of my little weather station. This time it has a fan to mitigate showing too high values when in the sunlight. You'll need the following…
Fits a standard 12V socket to a 22mm handlebar for motorcycles. Diameter of socket holder is 29mm. There's a cover when you leave the motorcycle outside in bad weather. Diameter 36,75mm, I had to print it at 99,5% to fit without falling…
Uboot - The Board Game (www.uboottheboardgame.com) I created some chip holders incl. press-fit lids for this board game. They're designed to fit each position in the game. I always added rows for activation chips. The number of activation…
Thought low profile is enough for my rather open setup of the USG and a TP-Link 8port low energy switch below. Works nicely, lets enough air through and supports the USG to sit comfortably. Thanks for the SketchUp files from wpns, but I…
With passthrough cable hole exiting to the side. Just mirror the model in your slicer, if you need it to exit on the other side. Fits most cases, no need to take the phone out. 16e version added as well.
For PLA printing, I open up the top of the Voron enclosure (and the doors a bit as well). I don't want to remove it fully to keep a bit of dust protection, so I designed this lift, which holds it in place at an angle in the back. At the…
Since the minimum setting for my CPAP fan on Voron 2.4 / Stealthburner is still too much of cooling for ABS, I designed this quick&dirty flow restrictor. In one position, there is no restriction, as used for PLA (I run the fan at 50%…
Without these, the Stuva backwall will vibrate and create noise when the printer moves quickly. Just print the side pieces 2-4x and the top/bottom pieces 4-6x, then just stick them in the gap between the backwall and the nut the wall sits…
To wszystkie aktualnie dostępne wyniki.
