Liczymy pasujące modele…
The three models are for the Toolgrid system. Ones I found online were not at the tolerance I preferred so I made these. They are .254mm smaller than the actual size keeping it nice and tight to the socket but not tight enough you can't…
Print at 15% and at most .3 layer height.
Works with the toolgrid system to hold all of your hex bits.
The cam is for keeping tools up against the walls and/or corners created by MaxTheSpy. there are two files for use, one at the standard 1" size and another at 1.75" for larger tools. Linked below is the walls and corners MaxTheSpy makes…
I made this after using a few other people had made. They always seemed to be a little snug on the square drive of the ½" ratchet so i made one that is slightly bigger internally. Works with toolgrid and can be paired with either the…
This holder works with the pittsburgh pro universal sockets that come in 3/8" and ½" drive. It is meant to screw down with the tool grid system.
I printed it in PLA at 25% infill and standing vertically.
These are deep socket trays to work with the toolgrid system and CASOMAN deep sockets. I am not sure if it will fit other ¼" drive deep sockets but you can print and try. I have given the files for both SAE and Metric. SAE I could fit on…
This attachment goes to the DeWalt leaf blower model DCBL722P1. Print it light and standing up. If infill is too high, it will sink on itself.
Made for the Shark Stratos vacuum but could fit others. Round area is 1 ½" outside diameter. and that should be the inside diameter of you vacuum hose. In the rectangular suction opening I added some neoprene to act like a soft scraper on…
Print in sets of 4 to holder your parallels in place during repeated operations. Uses 10x3 magnets. Print magnet side up and i used 100% infill.
To wszystkie aktualnie dostępne wyniki.
