Liczymy pasujące modele…
I printed the speedbrake vertically, narrow end to the plate with no supports and a brim for stability. I printed the two throttle levers horizontally with the round part of the knob of the plate. With supports for the stem. I printed the…
Print two and place on either side of the gantry to hold it level while you fix the gantry in place. use to check if the gantry has shifted or to hold the gantry while you work on the printhead. When using place the tools on either side…
Remixed version of drhollen's ZWO Seestar S50 light/dew shield - baffled that is automatically pushed off if the scope closes while it's fitted. I heated the top of the collar (opposite the push off tab so I could flex it to give a snug…
This is a mount I made for my Iphone SE so I could mount it on my Skywatcher Dobsonian telescope using the standard viewfinder dovetail mount. Should also it to any scope using the same finderscope dovetail. Used on Dob mount, but should…
This is a holder for Semco berry pins, it holds 2 reels of 40 pins. The reels are around 80mm in diameter. The lid will lock if you close it and rotate until it clicks into place.
This is a spacer block to suit a standard 18mm desktop there is also a Knob to take a stand 12mm Hex bolt for the Držák Turtle Beach VelocityOne FLIGHTSTICK The 3MF has a couple of modifiers to print 100% infill where the bol conacts the…
I made this bracket to mount a bin on the post for the table in my caravan, this keeps it off the floor and being kicked around. I use a plastic bag in the bin to make it easy to empty. My post is 60mm in diameter and I placed a sheet of…
To wszystkie aktualnie dostępne wyniki.
