Liczymy pasujące modele…
I don't care for the hotspots from the leds showing through the front panel. So I added a small piece that goes on top of the acrylic on the inside of each panel. Makes the light section a little bit smaller than the original, but it…
I like the changes Funkenjaeger made to the gridfinity DuPont jumper wire holder, but I also like the Gridfinity Ultra Light Bins by HuMa. This combines both.
My doors didn't slide back as well as I'd liked, so I added a little guide for the doors. Once everything is put together I used double sticky tape to find the best position for the guides and then screwed them in with wood screws.
Gridfinity Prusa MK4 Heatblock/Wrench Holder - holds 1 assembled Prusa MK4 heat block with nozzle, thermistor and heater along with the Prusa nozzle wrenches and 3 of the Allen wrenches included with the Prusa MK4. Bin size is 1x1x6…
I did it in two pieces so I didn't need to deal with internal supports. Lid has snap fit joints to securely attach to base. Printed on MK4 with Input Shaper - .4nozzle, .2layer height and rock marble polyterra PLA. Great original design…
Like the design, but needed it for a smaller handlebar size (22.5mm)
MK4, .4nozzle, .2layer height, prusaslicer with input shaping
Over time the window cord can dig a groove into the guide channel inside the window (see cover photo). This will stop the window shade/bug screen from moving and cause it to jam into place. This little piece sits in the window cord area…
Fits a single Slice Engineering Nozzle Torque Wrench: 1.5 Nm Gridfinity bin size is 1x2x6. Printed with .4mm nozzle and .2 layer height
I wasn't crazy about the top hinges that came with the Printer-box spool tank. They were too noisy for me. I replaced them with magnetic hinges. I used 20x5x2mm magnets ( https://a.co/d/1UpfRBX ). This uses the same screws as the original…
To wszystkie aktualnie dostępne wyniki.
