Liczymy pasujące modele…
I carry my elfbars in my pocket or backpack, this causes the inlet orfice to mug up with fluff and debris, so I designed this simple tubular case to hold it with a cap for the mouthpiece. Notable design features are a pinhole in the base…
I wanted to print the original model but was too big for my Mini. I managed to scale it to just over 85% to fit in the Mini's bed. All credits go to rvaccaro .
I scaled the original design in half on the Z axis to fit it in the Voron0. You'll need 2 per strip for adequate lighting, I also suggest you print 2 more to have a strip on both sides. They clip onto the extrusions and you can place them…
I only had 8mm round magnets at hand, instead of the 10mm in the previous remix. I printed it in PC, you could try PETG as well, I'm not sure how well it'll hold up
I needed a simple tape container to hold a spool of nickel tape. The drum has a slot to pull the tape out of and the lid is closed witha press fit and has a hole to grab on and open it. The drum fits spools of 80mm diameter and 7.8mm…
I wanted to try to put some flaps on the SpacePi x4's exhaust fans to reduce the amount of time the fans are on and to reduce the fan noise as well. I really liked @MandicReally design and simplicity so I remixed to be taped at the back…
An entry for the Prusa spoolcap competition. A spoolcap with a numbered selector from 1 to 8 and optional material tag. I printed everything with PLA but any material should be fine. 3 perimeters and 15% cubic infill, but any settings…
Print according the original instructions: PETG @ 0.2mm with 15% infill with the STRUCTURAL profile
To wszystkie aktualnie dostępne wyniki.
