Liczymy pasujące modele…
Contains both the desk and the chair. Desk is best printed on it's backside. Chair is in two parts, perhaps need a little support. Two parts of the chair needs to be glued togheter. Size is good for a blythe doll.
Replacement part for the parcelshelf of a Ford Ka (2009 - 2016). Best printed in PETG with minimal supports for best result.
Small little mount that can be used to mount a plank on top of a radiator. Use small screws to mount the brackets on the plank. Can be printed without supports but best to use a filament that is heat-resistent otherwise it will deform.
Wall adapter that can be used to fit an mobile airco outlet to a wallhole of 11cm. There is also a shutter to close the wallmount. The airco pipe can be easily removed from the wallmount if needed. Can be screwed in the wall with 4…
Vial holder in pentagon shape. Can be used to hold vials that are 2,2cm wide (can also be upscaled to fit bigger or smaller vials). We used the vial holder to hold vials with tea for our wedding as gift for the guests. The model is not…
Wonderful ergonomical ice scraper that can be used to scrape Ice off your car window in no time. Can scrape ice in all directions! Can be printed in PLA but needs supports in the middle for best result.
Mount to use a universal (cheap) Cobweb duster on the Leifheit telescopic handle. Can be printed in PLA with supports on.
Replacement part for electrical bike that uses a bafang battery. The part that holded the plug broke when sliding the battery in/out of the bike. The break occured at the red line on the picture of the original. To mount this replacement…
Small rack to put an Amber Incense block on. This way it can air easily and increase the smell without giving any stains. Can be printed with PLA, best to print it upside down and use supports.
To wszystkie aktualnie dostępne wyniki.
