Liczymy pasujące modele…
If you wish to be a distinguished gentleman, this is the bubble pipe for you! Created at my brother's request. My goal was to try and make a bubble pipe that could produce larger bubbles, instead of the standard heap of tiny bubbles that…
Gears print separately. Before snapping the gears onto the pegs, use an exacto knife to cut/clean out the cross sections for each peg. At some point I'm going to revisit this design to incorporate a pegboard and more gear shapes.
My wife wanted some hooks for the closet to hang the girls various backpacks and bags. Probably made the hooks a little larger than they needed to be…. but they seem sturdy enough with PLA.
Curves around 270 degrees so the poles do not fall out when it's hanging upside down. I inserted these magnets. 20x20x5, half way through the print. The gcode has a stopping point in it.…
Based on the Ancient One's Mandala from Dr. Strange. Assembly: I super-glued 2 little 5mm magnets together to make the center shaft that the medium sized piece sits on. This size magnet allows the small piece to rotate but also translate…
Before : After: Prints fine on a Prusa Mini. I suggest changing the filament colors 2 times to get outlines on the top and bottom. To save on filament and print time there is .3mf file that removes the bulk in the middle.
A simple deck box that locks shut. Press the side buttons to release the top cartridge. The cards are visible from the top and bottom for identification and reducing filament used. Box Sizes Exist For: Bicycle Standard Cards Flamecraft…
This is a simple mount to hold this cheap camera to monitor prints via a cloud solution. Blink Mini Camera Takes a 25mmx5mm circular magnet in the bottom.
Commissioned to make this Power Ranger's Dragon Dagger holder with a spot to put the figurine. To remove the platform for the figurine either use the attached prusaslicer file or just place a negative volume cube over that feature.
This print requires these 3 parts: Square nut, Screw (10mm), X-acto Blade (19) First print the blade holder and the blade pin Insert the blade (pay attention to the orientation), blade pin, and the square nut. Print the blade cover, but…
Designed by my 3 year old in photoshop! This one of a kind arm is a must have for any Buzz Lighters that happen to be missing their right arms.
58mm version is compatible and snug with this adapter : I'm pairing it with a peak design case on a pixel pro 9 that I really like. I haven't tested, but the 55mm version should work with standard apple magsafe, although I think there are…
There is a 2 hold design as well if you are worried about it rotating. Holds things with a diameter up to 35mm.
v1: I want to make the snap pieces a little easier to slide in the slots, and make a 5x5 version.
Cars go inside and if they fit then they meet the requirements to race. This box is based on these requirements. I suggest printing in something a little translucent.
The hello fresh orders seem to find there way to the back of the fridge. I wanted to put the cards somewhere we'll see them everyday to remind us what meals we have without them being out in the open. I suggest printing with the plastic…
To help with equal spacing of pennies in the bottom of the boxcar. Keep the drilling saw dust to mix with wood glue to seal the pennies in.
To wszystkie aktualnie dostępne wyniki.
