Liczymy pasujące modele…
It can hold up to 32 pieces of DIMM and up to 64 pieces of SO-DIMM modules. If you store modules with heatsink then the capacity may be less than ½. It's stackable design, but NOT compatible with the original. Printed from low cost 0.22mm…
This is my FIRST model created simply out from need to cover my homemade powerbanks / batterypacks since I've destroyed one of them by leaving it on table where I've had metal components. Short circuit was inevitable. So from now on, I'm…
Just one major change - hole on the side under display for SD card reader and USB port.
This is my model created out of need in tinkercad. It's tight fit, but works perfectly. Model is printed from PETG without rafts and supports, with infill 10% and layer height 0.2mm. You can probably print it from PLA, but then you should…
CZ: Potřeboval jsem krytku s chlazením na jeden svůj zdroj, tak jsem jej přeměřil a v tinkercadu načrtnul přibližný vzhled. Toto nejspíš není finální výtvor, ale už jsem skoro tam. Jeden ventilátor se mi zdál málo a nemám rád asymetrické…
To wszystkie aktualnie dostępne wyniki.
