Liczymy pasujące modele…
couldn't find a good pop up dispenser for sticky notes (the ones that come zigzag) So designed this simple dispenser. At first I left both sides open but since the top part with the opening weren't connected to the bottom it was very…
Wanted to use an old DirecTV bracket for my Starlink v2 dishy. Designed this to fit into the pipe and secured it with some screws. You can use screws or glue should work too. Printed in PETG
I like keeping my xacto knife and other pens in the larger side and I didn't have that many tools so I made it to fit the middle part. hope this is useful to some.
Needed to write with a pilot G2 instead of the Cricut Pens. Hope this comes in handy for someone. You need to cut the grip off for it to fit.
Print at .2mm and do a filament change at 2.2mm and insert 6mm x 1.5mm round magnets and continue the print so the magnets are embedded into the print.
print the two parts. insert toilet paper end through the slot and place TP inside. Then screw on the bottom holder piece to hold it in.
wanted to use a Peak Design Camera strap as a sling. Designed this for it to go through the magpul sling mount the peak design anchor keeps it in place. I printed this in PETG at 100% infill
PLEASE be responsible and don't get yourself or anyone else killed. This is strictly for when the car is in PARK, just like Tesla Arcade. I take no responsibility for the misuse of this device. Again, THIS IS NOT FOR UTILIZATION WHILE THE…
Needed a solution to carry the power brick when I put my light stand high so the brick doesn't dangle from the dc jack.
I printed this storage box for my dad to store his hearing aids overnight. It was tough removing the shelf to check the silica gel without getting the silica everywhere. So I remixed the shelf to have a little tab that folds out to easily…
printed this with 8 walls and 90% infill
To wszystkie aktualnie dostępne wyniki.
