Liczymy pasujące modele…
With this adapter you can build towers with Duplo and switch over to the Kulerbü stud format. That way you can go as high as the number of Duplo bricks you have. Both the fit to the Duplo bricks as the fit to the Kullerbü units is snug.…
Simple design to mount an inductive proximity sensor on your Elster V200 Watermeter. The sensor used is a “M12 DC 5V NPN NO LJ12A3-4-Z/BX-5V 300mA” sensor working on 5 volt. It triggers on the little red wheel in your watermeter and will…
Just a simple DS18B20 Temperature Sensor mount. I printed it with PLA but if you need it in a place that gets hot you better use something that can withstand the temperature. Slide the sensor in from the top or the bottom. It has a tight…
These are some simple plates you can put in a socket to protect them from little fingers (or the other way around, protect little fingers). They are easy to place but to remove them without the ‘key’ is not that easy. Printed the…
Simple endpiece for a Kullerbü track. Will catch 5 to 6 balls from running around in your home. I printed this from PLA.
This track piece is ment to combine two tracks into one. Speed of the balls cannot be to high or they will not stay in the track.
Simple shute to add marbles to the track. You can try to print it without support, but I did it with a little organic support just under the open part of the shute.
Sometimes when playing the wooden balls go so fast that they leave the track in a tight corner. Resulting in balls flying through the room. Place this guardrail on a srategic place in the track to keep things rolling as intended. I…
You can try to print it without support but I used a little to support the top of the arc.
This model goes with my DS18B20 (Waterproof) Temperature Sensor Mount and fits over the sensor to keep it out of direct sunlight and or rain.
To wszystkie aktualnie dostępne wyniki.
