Liczymy pasujące modele…
A simple HT / Walkie Talkie mount using the QUICK-CLIP system. Provided are 2 versions, a straight mount, and an angled 22.5 degree mount. I designed the angled mount for use on backpack straps so that the radio will properly sit straight…
This is a remix of BearEssentials eSun PLA+ spool drawers which I modified so that the drawers are printable as vase mode and added a convenient finger notch to make it easy to open the drawers from the spool. For the drawers I recommend…
A simple Christmas ornament of a pot leaf with a Santa hat! Was requested by a family member. Very simple model, just print it flat, designed to be very easy to print! I used a green PLA+ and painted the hat with red and white acrylic…
Recommended to use an SLA printer with a clear resin for best results. I used an Elegoo Mars 2 Pro and color dies to get transparent colored prints as pictured. If you like my work and wish to support me then you can buy me a coffee !
A simple hangable holder / organizer for up to 100 bits, 40 ¼ inch bits, and 60 5/32 bits. no supports required, print flat on its back. I used lightning infill since it does not have to be super strong. If you like my work and wish to…
This is a simple storage box for 608 bearings, it holds 3 rows of 7 so 21 in total. No supports required, very simple print. If you like my work and wish to support me then you can buy me a coffee !
I snapped the factory Kobra nozzle in the factory heater block so I decided I would just upgrade it with an E3D V6 I had on an old no longer functional printer, of course this demanded a mounting solution which I was unable to find…
This is a remix of the original QUICK-CLIP perpendicular buckle to drop the mount point to below the MOLLE webbing level, I needed this for a part so that it would clear another mount just above it. No supports are required, print as…
This sewing kit container is based on cheap dollar store sewing kits utilizing the QUICK-CLIP system . No supports are required, print as oriented in the models. The hinge hole is designed to use 1.75mm filament for the hinge. You may…
A simple replacement paddle for MFJ-564 Iambic keyer. Model is ambidextrous. The mounting holes are designed for 2mm bolt diameter. If you like my work and wish to support me then you can buy me a coffee ! Print Settings Printer: Elegoo…
This is a fun decorative toothbrush holder based on the idea of the DNA double helix. This model is fully parametric using OpenSCAD. There are 2 OpenSCAD files included, one is a standard toothbrush holder designed to hold normal standard…
Just a cute little ornament for the 2023 challenge! It comes in 5 parts, the sleigh, a left and right sleigh rail, and a large and small gift. Print 1 each of the sleigh, rails, and 2 each of the gifts (optional to put in rear of sleigh).…
To wszystkie aktualnie dostępne wyniki.
