P
Printablespixelpinguin
Bookmark
Print it with 100% infill
- Pobrania
- 849
- Polubienia
- 93
- Ocena
- 4,91
Wszystkie modele
Liczymy pasujące modele…
P
Printablespixelpinguin
Card Bottle Opener
This is an id card sized bottle opener that should easily fit into most wallets. All you need are two coins (I have designed different versions for different currencies). The bottle opener only bends the caps slightly when used, so you…
- Pobrania
- 296
- Polubienia
- 65
- Ocena
- 3,83
P
Printablespixelpinguin
Ikea ADILS / Table Leg - Cable Clip
Installation: Just push it on the table leg and it should snap into place. Print- Settings: I printed it with 0.25mm layer height and 10% infill Anything else: If you need anything else or have ideas for improvements, just dm me ;)
- Pobrania
- 290
- Polubienia
- 59
- Ocena
- 5
P
Printablespixelpinguin
Skate-/Longboard Wall Mount
Installation: This is a screw-in wall mount for any Skateboard with 60mm wheels. You can adjust for different trucks by simply increasing the distance between the two mounting parts. I used four 5x40mm screws for the upper part and double…
- Pobrania
- 201
- Polubienia
- 67
- Ocena
- 5
P
Printablespixelpinguin
Airpods Pro Stand
Installation: I glued some little rubber feet on the bottom to give it a little more grip. Print- Settings: I printed it with 0.10mm layer height and 20% infill Anything else: If you need anything else or have ideas for improvements, just…
- Pobrania
- 180
- Polubienia
- 19
- Ocena
- 4,5
P
Printablespixelpinguin
![Cableclip [3-10mm]](https://media.printables.com/media/prints/74726/images/808365_680f501e-d99e-41b5-8617-925c7944374b/img_5264.jpg)
Cableclip [3-10mm]
Installation: These are cable clips for different cable diameters. I sticked them to the wall using double sided adhesive tape. Just measure your cable and print the next bigger and smaller diameter clip, because they only take about 5-10…
- Pobrania
- 76
- Polubienia
- 10
- Ocena
- 5
P
Printablespixelpinguin
Headphone mount for table
Installation: I used one screw to fix it to the table. If you want to stick it to the table there is a version without the holes. Print- Settings: I printed it with 0.15mm layer height and 20% infill, no supports needed just lay it on the…
- Pobrania
- 66
- Polubienia
- 6
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.