Liczymy pasujące modele…
I drew up a QR plate for my gorilla pod, because the original one broke. The hole on the bottom has got a diameter of 19mm to fit the screw with a “handle” I had laying around. It should print just fine without supports, but you might…
I needed some feet for a 3.5" WD Red hard drive and quickly designed some in Fusion360. No supports needed! Lay flat on the bottom side where the hole is (see last image). The hole was designed with the following technique and prints…
Lay flat as seen on the first image. Remixed for M4 socket head screws and made it printable without supports + prettified it a bit.
To wszystkie aktualnie dostępne wyniki.
