Liczymy pasujące modele…
A cute and spikey, articulated worm. I had best results with a brim, due to low bed adhesion. Can be scaled down , but the walls are thin as it is and bed adhesion will decrease. I also set my printer with a bit of z lift and to avoid…
Clip is designed to tightly hold a 5mm lid in place, on a Tetra Connect 28gal Bow Front Aquarium. Petg is recommended for strength and uv resistance, as its intended for use with reptiles. A model file is included with adjustable…
This is a light mount designed for clip on lights. Fits Exo Terra Print in PETG with 15% infill. Needs supports.
Print in PETG. One side adheres to bed better than the other, so pay attention to orientation and check bed adhesion. Pretty easy, you can do it! No supports needed, and scales well.
This is designed to fit the irregular top on a bell aquarium, as the top was not perfectly round. It has 2mm holes to vent, but negate any life from escaping through the holes at least. As my tanks top is oblong, there is a gap in one…
My best bearing yet! Large rollers for smooth running bearing. Use a string with a knot at the end and wrap the string around the groove. Hold the top and side, then pull string and let go of the top and watch it go. Normal print…
To wszystkie aktualnie dostępne wyniki.
