Liczymy pasujące modele…
I don't ride at night much so I usually just have them in my bag. I got tired of having to dig them out to use or charge, so I made a few things to keep them organized during transport or charging. The curved mount is a bit harder to make…
I have a Ride1Up Roadster V2 ebike that uses this display that is somewhat common on other ebikes. But the problem with it is the plastic is brittle and the clamp is just a bit smaller than my handlebar so you can't really tighten in all…
***Made for Acedeck's NYX-Z1, the bar diameters are 21mm and they are 49mm apart center to center…not sure this will fit other bullbar specs. Shredlights' square truck mounts didn't work on this board with the bullbars installed, I…
For those who can't seem to get the Shredlight's handlebar mount tight enough on bumpy rides, I made this one to utilize zipties. Just add a thin rubber layer then cinch it down as hard as you can. Hope it helps…I never ended up using…
Another version of the compact mount. After getting my hands on a set of SL-1000+ light, I realized the light is roughly 30mm longer. I tested it on my original mount and it still works, but the SL1000 is positioned a bit too forward and…
I made this for the Segway MiniPlus which I got second or possibly third hand. the hubs were pretty badly scratched up and also dug into the sidewalls of the tire, so I took it off, but then the led was just too bright and exposed so I…
To wszystkie aktualnie dostępne wyniki.
