Liczymy pasujące modele…
Here is a cat toy with inner ball built inside of it. my cat goes crazy about this one! Brim and some supports are recommended, so you need to clean up the print afterwards to set free the ball inside. have fun!
printing orientation on the side, did not need supports, 3 outer layers minimum, honeycomb infill 20% minimum. Have fun! Pestle away! You can figure out the wooden supports for concrete.
Put flat side down with slicer. Draft quality is sufficient with 15%infill. Tighten screws carefully not to brake the handle. not too tight. Put some inner tube between handle and bike shaft. you will need M5x15x2, M5 nyloc bolt x2 and…
Extra ear for your helmet strap to hang your mask from. turn the strap and slide the clip back and forth to install it.
To wszystkie aktualnie dostępne wyniki.
