Liczymy pasujące modele…
These two chin mount sizes were designed to snap into place on the ASTARS SM5 helmet. They have a generic mount piece on the end to primarily suit the GoPro. I printed with a 0.4 nozzle, at 0.12mm 80% infill Print on an angle (see…
This mount was specifically designed to fit the handlebar bracket for the Ducati Monster. The center of the design has a mount that is compatible with quadlock. One M5 insert is required for the centre hole, and 4 x washers (1 for each…
A remixed earplug case with hinge pin holes small enough to use a paperclip, and a ring for hanging on a key chain. Support may be required for the keychain loop
Created to store and organise recipe base packets, like those from Master Foods STL files for both ‘Sauces’ and without. Length 111mm x width 166.5mm x height 100mm Each compartment leaves a space of 26mm for a packet. NOTE : keep the…
I got tired of hanging the helmet over the mirrors when doing a quick stop, and then having to re-adjust the mirrors each time. So I created a thick clamp with a hinge to house a small padlock, that could be attached to the frame of the…
To wszystkie aktualnie dostępne wyniki.
