Liczymy pasujące modele…
Just pop in seven switches, five standard size keys, and two 1.75u keys then click-clack away! Also includes a version with lanyard hole where a USB-C cable would connect. Cherry MX brown switches and XDA key caps shown in photos.
I recommend printing in the orientations shown in 3rd picture, with a large brim to keep the edges from pulling up off the bed-plate. No supports necessary, but brims are highly encouraged. This is modular so it can be used with just the…
Here is my first attempt at a printable PC case! 'LittleBlock' it's a compact, simple to print, and easy to assemble PC case that I intended to be modular and easily customizable. all of the panels can be easily swapped or removed without…
I created this to attach a sturdy and easily removable wooden work surface to the top of my toolbox stack, but it can be used to lock just about anything to the top of the stack system. You can use two side by side for a full width…
Correct a small annoyance with these slip in spacers. I have no idea if the axles are standardized between 1:64 product lines, but these should slide onto the axle with a little friction while still allowing the car to roll easily. I used…
This is a printable Stabilizer leg with optional Foot Rest or "Dead Pedal" that can be a great place to rest you feet if you don't have a clutch pedal or a mount for the pedals. No supports should be needed! The stabilizer can be…
I created this shelf so I had somewhere accessible to store longer tools like 18inch breaker bars, pry bars, and extensions. Once assembled the shelf can simply be lowered into place. The shelf leaves plenty of space at the bottom of the…
[Feel free to add a comment if you have any suggestions for this design!] .STEP added for easy customization An organizer for bits and bit holder that clips onto the side of the Hart Toolbox 2 drawer box. Added a loop to the top to help…
Created this for a friend as they did not like how the Vero V looks. Top should be printed from the flat side and same with the Base (They should be oriented correctly for printing already). Supports recommend for the rectangular…
printed with cheap PLA at .2mm, no supports should be needed. I recommend gluing nonslip pads the bottom. Have used for a couple weeks and seems to be holding up to the heat for now. UPDATE v2: Very slight warping after a few months of…
Make this platform as tall as you dare by editing the leg length. (Default 10cm height).
This compact organizer was made to fit This Socket set , may also fit other similar sets. To remove sockets from clip simply pull them up and away from the edge, it takes a little more effort to remove sockets in the outer corners but is…
An 84mm model of the 801 Grand tower with a hanging loop for the architecture enthusiasts out there.
To wszystkie aktualnie dostępne wyniki.
