P
Printablesnouc
Motorcycle chain "slack ruler"
Hardware required: socket head screw: M5, length: 15-35mm
- Pobrania
- 977
- Polubienia
- 152
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
Printablesnouc
Oxford Heated Grip Mount
It position controller as much to grip as possible. Cavity and additional holes is for water escape. Maybe overkill but... Requires rubber/silicone band. I've printed one from TPU. Screws: M5x20
- Pobrania
- 85
- Polubienia
- 8
- Ocena
- 5
P
Printablesnouc
PQ34 Audi TT 8N lift supports
OEM parts made with EPDM Printed in TPU with 40D hardness Insert 100% infill, end up much harder than original EPDM (Not yet tested outer part, but i suggest non 100% infill) Support needed Should fit into: Audi A3 Mk1 (8L) Audi TT Mk1…
- Pobrania
- 70
- Polubienia
- 2
- Ocena
- 0
P
Printablesnouc
VIFLY ShortSaver V2 case
Remove original head shrink tube. before putting into case. If you planning to use dark filament i suggest to paint insides of led holes with some bright or reflective color Hardware: M3x10 screw M3 nut (optional, there is "no nut"…
- Pobrania
- 69
- Polubienia
- 5
- Ocena
- 0
P
Printablesnouc
qx7 3x 18650 case with original battery pads
Use original battery pad. No soldering, no cutting. Almost plug'n'play I have to punch a hole in positive pads to ext
- Pobrania
- 46
- Polubienia
- 3
- Ocena
- 0
P
Printablesnouc
Vifly finder 2 and RP2 TX box
2xM3 screws and nuts required. Case does not block buzzer, led or light sensor Decicate design for armattan beaver, but might fit for other frames it tooks 30mm screw pattern
- Pobrania
- 30
- Polubienia
- 6
- Ocena
- 0
P
Printablesnouc
Armattan Beaver Cage slider
I suggest print on side with supports and brim
- Pobrania
- 28
- Polubienia
- 1
- Ocena
- 0
P
Printablesnouc
Armattan Beaver arm protector
Designed to be printed from hard material, ASA, PET, etc Parts are interlocking each other during assembly. Screws for motors needs to be 0.5mm longer than those used normally. In my case, the screw is only one last turn too short. So I…
- Pobrania
- 18
- Polubienia
- 1
- Ocena
- 0
P
Printablesnouc
Armattan Beaver GoPro Session holder V2
No need for full disassembly to take of top plate. Just two rear screws Files with ms suffix - are with partial manual supports, for me print came after, just need to cut out holes with scalpel Improvements compared do V1 Moved forward,…
- Pobrania
- 15
- Polubienia
- 1
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.