Liczymy pasujące modele…
Simple 18650 case with no extra parts or caps to lose. Drop the battery in the bottom ring then tilt in and snap in place. Print instructions Category: Electronics Print Settings Printer Brand: Prusa Printer: i3 MK3 Rafts: Doesn't Matter…
60x60x20 corner bracket that will accept M3 screws. Prints flat without supports.
Hall passes I designed for my wife Pernille Ripp. I used rocketburn11 nurse pendent found here: https://www.thingiverse.com/thing:289124 The Office logo from jakestaby found here: https://www.thingiverse.com/thing:3118823 I recommend…
I wanted a more robust drop-in T-nut for my Prusa 30x30 rail. Warning Straight off the printer they will go in but it will be difficult to get them back out. A quick sanding to the outer edges will allow them to come out easier. The hole…
Four kids, one towel bar...These snap onto my 15.75mm diameter towel bar so they don't fall off when the kids pull off their towels. I made them extra wide for strength. Print instructions Category: Bathroom Print Settings Printer Brand:…
I wanted a dial to better fit my fat fingers while still being able to spin it around with one finger like the original. Print instructions No supports needed
This is a work in progress. Inspired by Ethix Facehugger https://www.team-blacksheep.com/products/prod:ethix\_gopro\_mask , I wanted minimal protection for my GoPro Hero 7. The one I printed at 40% infill came out to 8g in weight. GoPro…
Attaches using the holes in the bottom RCMC Taranis dock. RCMC Taranis dock found here: https://www.thingiverse.com/thing:1323103 Print instructions Category: Hobby Print Settings Printer Brand: Prusa Printer: i3 MK3 Rafts: No Supports:…
There are 2 versions of the mount, 1 strap (front only) or 2 strap (front and sides). This was inspired by Project 399 mount https://www.project399.com/collections/products/products/gopro-mount , with the offset front strap mount to allow…
Change List: -Added motor bumpers -removed logo to recess the center pocket 1mm more to allow for the VTX to sit under the FC -motor pads 2.4mm thick to better suit 2mm motors screws Update 11/29/19 - Added 08XX motor size. Beware, I…
To wszystkie aktualnie dostępne wyniki.
