Liczymy pasujące modele…
This case was designed to fit an 8x32 LED matrix and a microcontroller in the back. There are two different case thicknesses to give you a little extra space for the hidden microcontroller. The case is designed to be a tight fit for the…
Cut out the original EVA 2.4.0 V6 mount to fit the Creality Spider 3.0 hotend in the mount. Use the flattest edge to lay on the build plate, no supports needed.
Replacement suspension bushings for a 2004 Polaris Sportsman 500. There are probably other Polaris models that these fit. I purchased a set of these and they were made of hard plastic and I wanted to be able to print them in TPU so I…
Replacement center console latch for a 2014 era Buick Enclave. Should also fit similar model years and related vehicles like the Chevrolet Traverse and GMC Acadia. Print the model with supports either on its back or on the side as shown…
Printed with PLA+ and would probably recommend TPU for a little flex to make installation easier. Used a slight amount of heat where the inside squeezes in to make installing over the pin recess easier. 1995-2005 base neons need 3 small…
Replacement foot for an older model GE branded crockpot sold at Walmart. Originally the crockpot comes with 3 feet and over time become brittle and break. This model fits in 4 evenly spaced holes in the bottom of the crockpot and are…
Rear sway bar bushings for the first generation Dodge Neon. 16mm and 22mm STLs included. Recommend printing in 95A TPU at 100% infill. Print with the sway bar holes on the bed. No supports needed with good cooling for overhangs.
This is the knife blade drive gear for the Dormeyer Silver Chef electric slicing knife that dates back around to the 1950's. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: Yes Resolution: 0.2 Infill: 100…
Simple replacement foot for a chair that I had that was crushed during a move. Printed w/ 4 walls, top, bottom and whatever infill you feel like. STEP included if you want to tweak the design.
Control arm bushings for a 95-99 Dodge Neon. The sleeve will need to be sourced or reused from an older set of bushings. Recommend 100% infill using 95A TPU. STEP file included for easy changes. Grease generously and press them in by…
To wszystkie aktualnie dostępne wyniki.
